Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Static NAT on PIX 501 help

I have PIXA (192.168.27.0) connecting to PIXB (192.168.1.0) with a VPN.  I would like to NAT the PIXB network to 10.10.1.0 when it connects to PIXA, so that when I do a "sh ipsec sa" on PIXA it shows the remote ident as 10.10.1.0 instead of 192.168.1.0.  I have attached my PIXB config.  Would somebody mind looking it over and telling me what I am doing incorrectly?  Thanks for any ideas.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Static NAT on PIX 501 help

1. remove "nat (inside) 0 access-list NO-NAT"

2. change acl 90 to "access-list 90 permit ip 10.20.1.0 255.255.255.0 192.168.27.0 255.255.255.0"

3. change ACL on the other end as well.

1 REPLY

Re: Static NAT on PIX 501 help

1. remove "nat (inside) 0 access-list NO-NAT"

2. change acl 90 to "access-list 90 permit ip 10.20.1.0 255.255.255.0 192.168.27.0 255.255.255.0"

3. change ACL on the other end as well.

185
Views
0
Helpful
1
Replies