Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Static with ACL

i have one global ip address x.x.188.5 and I have to servers 192.168.1.219 and 192.168.1.220. I want to advertise these servers over

the Internet on the following HTTPS & SSH.

How can i advertise these servers with one global IP address. Please help me out

one static entry works fine but when i try to bind second IP with global IP i am getting error.

  • VPN
2 REPLIES

Re: Static with ACL

Dear Waseem

You can use port-forwarding, have a look at:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00804708b4.shtml#t10

Please rate if helpful.

Regards

Farrukh

Re: Static with ACL

but if you wants to use the same port for both servers will not work

it must use each port for one server

for example ssh for server1 and hhtps for other server

because u are using one pub IP

for example

static(inside, outside) tcp interface 22 192.168.1.219 22 netmask 255.255.255.255

static(inside, outside) tcp interface 443 192.168.1.220 443 netmask 255.255.255.255

then make an ACL on the outside interface that allow traffic to these ports

please, if helpful rate

87
Views
0
Helpful
2
Replies
This widget could not be displayed.