Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Stun server and NAT

I need to operate a public stun server for voice. I want to put it on the dmz and then static nat public ip's to its internal ip addresses. It needs to respond on its publc interface however it is failing because of the natting.

1 REPLY
Bronze

Re: Stun server and NAT

Refer to the ATA 186/188 administrator guide for information on STUN support.

http://www.cisco.com/en/US/docs/voice_ip_comm/cata/186_188/3_0/english/administration/guide/sip/SIP88CH4.html

Cisco devices use a different method to avoid having to use STUN in the first place, using the VIA: option so they can

register correctly with the SIP server. You'd configure this per this doc on the ATA:

Look under "receiver tagged VIA header"

http://www.cisco.com/en/US/products/hw/gatecont/ps514/prod_release_note09186a0080109764.html

To maintain NAT/PAT translation for a session, the Cisco ATA 186 can now be configured to periodically send dummy UDP packets to a server (the Cisco ATA 186 does not expect any response from the server).

Here's some NAT related information that may help you with your situation:

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_administration_guide_chapter09186a00800c4b87.html

(see "NAT Gateway" and "NAT/PAT Translation" )

1573
Views
0
Helpful
1
Replies
CreatePlease to create content