Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Telnet and SSH

Is it possible to have another public IP address (i.e. 66.102.7.000) to telnet and SSH to the ASA 5510 remotely?  If it is possible, how would you setup the telnet and SSH?  Attached is the config.  Thanks.

Laura

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Blue

Re: Telnet and SSH

laurabolda wrote:

Thanks for your prompt response, Jon.

For clarification, if my computer IP address is 66.102.7.10, can I SSH to the ASA (outside interface 109.66.25.80)? If I can, how would you set it up on the ASA?  Is it the same command as your previous response?

Thanks.

Laura

Laura yes it would be -

ssh outside 66.102.7.10 255.255.255.255

Jon

Hall of Fame Super Blue

Re: Telnet and SSH

laurabolda wrote:

Thanks for your prompt response again, Jon.  Your command works.  But, I am not able to SSH to the ASA from my computer 66.102.7.10.  In your previous reply, you said I need to setup the domain name, crypo key generated, etc.  How do I setup all the prerequisities so that I can SSH to the ASA?

Also, can I setup SSH on the selected subnet?  For example, can I do this?

SSH outside 66.102.7.0 255.255.255.0

and

SSH outside 66.102.16.0 255.255.255.0

Thanks.

Laura

Laura

This doc gives the full details for setting up SSH on an ASA firewall -

ASA ssh configuration

Yes you can use a subnet rather than a host entry as you have done above.

Jon


6 REPLIES
Hall of Fame Super Blue

Re: Telnet and SSH

Laura

SSH yes, telnet no.

You cannot telnet from the outside of the ASA to the ASA itself unless the telnet is within an IPSEC tunnel.

For ssh, assuming all the other other things have been setup ie. domain name, crypto key generated etc..

ciscoasa(config)# ssh 66.102.7.1 outside

Jon

Cisco are currently donating money to the Haiti earthquake appeal for every rating so please consider rating all helpful posts.

New Member

Re: Telnet and SSH

Thanks for your prompt response, Jon.

For clarification, if my computer IP address is 66.102.7.10, can I SSH to the ASA (outside interface 109.66.25.80)? If I can, how would you set it up on the ASA?  Is it the same command as your previous response?

Thanks.

Laura

Hall of Fame Super Blue

Re: Telnet and SSH

laurabolda wrote:

Thanks for your prompt response, Jon.

For clarification, if my computer IP address is 66.102.7.10, can I SSH to the ASA (outside interface 109.66.25.80)? If I can, how would you set it up on the ASA?  Is it the same command as your previous response?

Thanks.

Laura

Laura yes it would be -

ssh outside 66.102.7.10 255.255.255.255

Jon

New Member

Re: Telnet and SSH

Thanks for your prompt response again, Jon.  Your command works.  But, I am not able to SSH to the ASA from my computer 66.102.7.10.  In your previous reply, you said I need to setup the domain name, crypo key generated, etc.  How do I setup all the prerequisities so that I can SSH to the ASA?

Also, can I setup SSH on the selected subnet?  For example, can I do this?

SSH outside 66.102.7.0 255.255.255.0

and

SSH outside 66.102.16.0 255.255.255.0

Thanks.

Laura

Hall of Fame Super Blue

Re: Telnet and SSH

laurabolda wrote:

Thanks for your prompt response again, Jon.  Your command works.  But, I am not able to SSH to the ASA from my computer 66.102.7.10.  In your previous reply, you said I need to setup the domain name, crypo key generated, etc.  How do I setup all the prerequisities so that I can SSH to the ASA?

Also, can I setup SSH on the selected subnet?  For example, can I do this?

SSH outside 66.102.7.0 255.255.255.0

and

SSH outside 66.102.16.0 255.255.255.0

Thanks.

Laura

Laura

This doc gives the full details for setting up SSH on an ASA firewall -

ASA ssh configuration

Yes you can use a subnet rather than a host entry as you have done above.

Jon


New Member

Re: Telnet and SSH

Thank you very much, Jon.  Your instructions and documentation work.

Laura

441
Views
0
Helpful
6
Replies