I recently got a Cisco 2801 that is running IOS 12.4(25g). Later I purchased an AIM-VPN/SSL-2 .
I read this document on how to enable the AIM card. The document says I should use the crypto engine aim 0 command to enable the card. There is no crypto engine aim command. http://www.cisco.com/c/en/us/td/docs/ios/12_4t/12_4t11/htvpnssl.html
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...