Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Tunnel established but no traffic with VPN3000

I'm able to establish a lan-to-lan tunnel between my vpn3000 concentrator and a partner (using checkpoint or netscreen gateway) but i can't see host on the remote lan.

During a ping , i see my 'bytes Tx' counter increments but the Rx stays on 0.

thanks for your help.

Morgan.

2 REPLIES

Re: Tunnel established but no traffic with VPN3000

Hi

Are you seeing the Rx counters on Concentrator side or at the netscreen/checkpoint side ??

I feel you need to check out the natting config on the other end (remote end)(thats if you are checking this counters at the concentrator side then do check out the nat config at the netscreen/checkpoint end).

I suspect that may be one of the possible reason for this problem..

regds

New Member

Re: Tunnel established but no traffic with VPN3000

thanks for your answer,

i'm seeing counters on concentrator side and don't have the hand on the remote end.

My partners tell me , they send traffic to my local lan through tunnel but i can't see any packets coming...

137
Views
0
Helpful
2
Replies
CreatePlease login to create content