Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Tunnels established between ASA 5510 and PIX 501 no traffic flows anywhere?

I an new to the ASA and have experience with Pix. We presently have an established HUB and Spoke using Pix 501's. I purchased an ASA 5510, and have configured it as a Easy VPN Server. I can establish successful tunnels to all devices, the problem is that no traffic flows down tunnels, and browsing the internet through ASA won't work. I used a configuration posted in the Technical Documentation site for this configuration. I used two ACL's, one for No-Nat and one for Tunnel as specified. Why no traffic flow at all? Running config is attached.

2 REPLIES
New Member

Re: Tunnels established between ASA 5510 and PIX 501 no traffic

You only have one route setup on the ASA. You need to configure routes so that it knows how to route to the tunnel.

New Member

Re: Tunnels established between ASA 5510 and PIX 501 no traffic

I found the problem and would have responded sooner if I could find this post.. The problem was that I had the security levels backwards on the interfaces 100 for outside interface and 0 for inside interface.. No wonder no traffic flowed!

149
Views
0
Helpful
2
Replies
CreatePlease login to create content