Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Two Cisco 1760 and PIX506 VPN redundancy question

Hello

A-End two Cisco 1760 and different ISP provider each C1760 WAN Internace.

HSRP Standby IP added on LAN interfaces both C1760,if Primary ISP leased line downed,then swiched to other C1760 to Internet.

B-End is PIX506 added two peers IP address for both A-End C1760.

At A-End if recovered leased line down,then back to primary router to Internet.

However B-End PIX try to connect VPN to A-End Primary C1760 router ? or keep connect with Secondary C1760 router ?

  • VPN
2 REPLIES

Re: Two Cisco 1760 and PIX506 VPN redundancy question

It will stay with C1760 router until the isakmp session is cleared. YOu can manually clear it or wait for the secondary link to go down... when the PIX tries to establish IPSEC tunnel fresh, it goes to the primary router.

hope this helps.. all the bst...

Raj

New Member

Re: Two Cisco 1760 and PIX506 VPN redundancy question

Thank you for your advice.

Is there any good way to avoide "It will stay with C1760 router until the isakmp session is cleared." ?

105
Views
0
Helpful
2
Replies