Please can someone help with the following; I have an ASA 5510 running v8.4(3)9 and have setup a remote user VPN using the Cisco VPN client v5.0.07.0410 which is working appart from the fact that I cannot access resources on a secondary subnet.
The setup is as follows:
ASA inside interface on 192.168.10.240
VPN clients on 192.168.254.x
I can access reources on the 192.168.10 subnet but not any other subnets internally, I need to specifically allow access to the 192.168.20 subnet, but I cannot figure out how to do this please advise, the config is below: -
Result of the command: "show startup-config"
! ASA Version 8.4(3)9 ! hostname blank domain-name
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...