Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unable to route between Quad Cards on a Pix 515e

I am having routing between ports on an individual Quad card and between Quad cards. I can however, route from the quad cards via the interfaces on the actual pix.

The pix I am using is Pix 515e and the software version is 6.2.3. All routes and configs appear correct.

Can anyone advise ?

Cheers

Mike

5 REPLIES
Silver

Re: Unable to route between Quad Cards on a Pix 515e

how many interfaces do you have? if you have a unrestricted license, a 515 supports a max of 6 physical interfaces (a quad card and the 2 onboard nics).

post your config

New Member

Re: Unable to route between Quad Cards on a Pix 515e

There is one Quad Card containing 4 ports and the Pix has two of its own interfaces, 6 in total

New Member

Re: Unable to route between Quad Cards on a Pix 515e

I'm afraid that we are unable to provide you with a copy of our config. That would be a breach of security.

We are quite convinced that the problem does not lie with our config. It has also been stripped down to the bare basics

New Member

Re: Unable to route between Quad Cards on a Pix 515e

You may be missing static mappings between the interfaces?

New Member

Re: Unable to route between Quad Cards on a Pix 515e

If this isn't licensing, is it because you have

the interfaces set at the same security level?

I am only asking because it sounded like you are

able to route between these interfaces and other

interfaces (outside and inside).

If I recall, interfaces set to the same security

level are not able to communicate to each other.

--- HTH ---

165
Views
0
Helpful
5
Replies
CreatePlease login to create content