Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

URL Filtering through the host based Ip address

Hi ,

One of our customer insisting on go for host base url filtering. menas the inside host i.e one group of user has to browse only few websites & another group has to browse only other few website. & block all the P2p softwares . this has to done in ASA 5510 using CLI mode not using any proxy server & CSC .

please let me know any one has config or document

regards

PAdmanabha

5 REPLIES

Re: URL Filtering through the host based Ip address

New Member

Re: URL Filtering through the host based Ip address

Hi, the document what u have mentioned is again the URL filterning is happening through the Websense or N2h2 Server. i required only though the ACL based url blocking & allowing for particular inside users.

Re: URL Filtering through the host based Ip address

read it carefully.

you can URL filterning without Websense or N2h2 Server

by the way, you can use common ACLs, if you know servers' ip addresses.

New Member

Re: URL Filtering through the host based Ip address

my requriment is particular inside host i.e one group of user shld browse only allowed website & another group alowed some other website & block all the p2p downloading like torrent , bit torrent. in ACL i can't block each & every websites. so si there any menthod to block & allow for particular websites.

Re: URL Filtering through the host based Ip address

304
Views
0
Helpful
5
Replies