I would like to know if there is a way to configure a static tunnel with a VTI on my end connecting to non-Cisco equipment on the remote end. I have a 7206 running 12.4(22) with multiple DMVPN tunnels. For the L2L tunnels, I am currently using a crypto map applied to the physical interface. My question is, can I create a VTI and connect it to some 3rd party? Would the remote end need to also have a VTI and be in the same network as my VTI (I would be using RFC 1918 address space on the VTI)?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...