Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

V7 upgrade failed from 6.3

I tried doing the upgrade. After TFTPing the image all the Pix does is:

Cisco Secure PIX Firewall BIOS (4.0) #0: Thu Mar 2 22:59:20 PST 2000

Platform PIX-515

Flash=i28F640J5 @ 0x300

Use BREAK or ESC to interrupt flash boot.

Use SPACE to begin flash boot immediately.

Reading 6681088 bytes of image from flash.

And then it just cycles back and forth. I got it back up with the old firmware. Any ideas how to get around this?

1 REPLY
New Member

Re: V7 upgrade failed from 6.3

I have seen this kind of problems if there are any licencing issues. Make sure you have the proper licence. If you have a failover licence bundle, then the image will not work properly when loaded on a standalone PIX.

118
Views
0
Helpful
1
Replies
CreatePlease to create content