Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Community Member

View trustpoint used for ISAKMP in IOS?

When a router is configured for multiple trustpoints and all trustpoint certificates are valid for phase 1 authentication, is there a way to see which trustpoint was used for an IPSec tunnel outside of debug isakmp. I'd like to look at a DMVPN hub and see what trustpoints were used by the spokes. These tunnels are up and active.

Any thoughts on a show command or possible hidden command?

Thanks,

Mark

1 REPLY
Highlighted
Silver

Re: View trustpoint used for ISAKMP in IOS?

I think when multiple CA trustpoints are specified within a single profile, ike will match only the last trustpoint configured.

145
Views
0
Helpful
1
Replies
CreatePlease to create content