Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPN and Annyconnect on the same port

Can you configure asa firewall to allow anyconnect vpn connection and then allow the annyconnect user traffic to go across vpn tunnel on the same firewall to remote site? Users on local lan can connect to remote site via vpn tunnel but not anyconnect users.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

VPN and Annyconnect on the same port

Sure, this is a common requirement. You just need to make sure to include the AnyConnect users' address pool in your access list referred to by the cryptomap used in the site-site tunnel.

2 REPLIES
Hall of Fame Super Silver

VPN and Annyconnect on the same port

Sure, this is a common requirement. You just need to make sure to include the AnyConnect users' address pool in your access list referred to by the cryptomap used in the site-site tunnel.

New Member

VPN and Annyconnect on the same port

Thank you!

I found a document for anyone has the same issue:

http://packetpushers.net/cisco-asa-8-38-4-hairpinning-nat-configuration/

287
Views
0
Helpful
2
Replies