I have some under stnading about firewalls but very basic with VPN technologies and terminolgies. I need a kind help from your side. I have to create a Site-to-Site VPN over internet (IPSec VPN). I have to fill the below form and send to the other site, other site is a Telco they are requesting the below details from my side. My side i have a firewall on which i will create the VPN, and the Firewall connects to one ISP with a Public IP on the outside interface. I should mention the VPN Interface IP some where, that much I know, but -
The peer/gateway IP addresses is likely the public IP address assigned to your Firewalls Internet facing Interface. The source/remote IP addresses are likely the LAN IP addresses (Encryption domain) from which you'll be originating traffic
Typically there are more paramaters to agree upon. Is this all you've been asked for?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...