Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VPN between PIX and Check Point NG (R55) broken after PIX upgrade

Hi,

I had an IPsec VPN working well between a PIX appliance (running 6.3(3)) and a Check Point NG (R55) gateway. The PIX was upgraded to 7.1(1) and now the VPN will not re-establish. Unfortunately, the PIX appliance is at a remote customer site and I only have direct access to the CP box. But I was told by Cisco support engineers that with 7.1(1), IKEv2 is no longer supported (only IKEv6 or IKEv7).

Does anyone have any information on support for IKEv2 in 7.1(1)? Has anyone had similar interoperability problems after a 7.1(1) upgrade?

Thanks in advance.

-rlanio

1 REPLY
Silver

Re: VPN between PIX and Check Point NG (R55) broken after PIX up

Downgrading the PIX to your older version would be a workaround for now. I have not heard of IKEv6 or v7? What is good about this?

158
Views
0
Helpful
1
Replies
CreatePlease to create content