Vpn between V2 and V3 RV0xx routers

[zsolt.renyi]

Hi

I'm trying to setup a VPN between an RV042 V3 and an RV082 V2 router. They get connected but no traffic gets through the tunnel. I tried with and without firewall,DPD, Keepalive, forward secrecy but nothing helped. What should I do? I don't want to throw out the V2 routers. V3 to V3 connects fine.

Thanks

[zsolt.renyi]

Never mind

The problem was that when I tested the two vpn endpoints where connected directly and they had no access to the default gateway. The IP addresses on the interfaces where on the same subnet, and the tunnel got connected but so I don't know why the router needed the default gateway, especially that with two V3 routers the same configuration worked.