Rizwan
Thank you
I am running ISA on my Windows 2003 server its ip address is 192.168.69.15
I think I have Radius setup can you check my config?
Here it is and I highlighted the vpn commands
-----------------------------------------------------------------------
Cisco Router and Security Device Manager (SDM) is installed on this device.
This feature requires the one-time use of the username "cisco"
with the password "cisco". The default username and password have a privilege le
vel of 15.
Please change these publicly known initial credentials using SDM or the IOS CLI.
Here are the Cisco IOS commands.
username privilege 15 secret 0
no username cisco
Replace and with the username and password you want to use
.
For more information about SDM please follow the instructions in the QUICK START
GUIDE for your router or go to http://www.cisco.com/go/sdm
-----------------------------------------------------------------------
User Access Verification
Username: netman
Password:
MyRouter#show config
Using 6108 out of 131072 bytes
!
! Last configuration change at 21:16:45 EST Fri Dec 30 2011 by netman
! NVRAM config last updated at 21:16:48 EST Fri Dec 30 2011 by netman
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname MyRouter
!
boot-start-marker
boot-end-marker
!
logging buffered 51200 warnings
enable secret 5 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
!
aaa new-model
!
!
aaa group server radius sdm-vpn-server-group-1 I think this is it??????????????
server 192.168.69.15 auth-port 1645 acct-port 1646
!
aaa authentication login default local
aaa authentication login ciscocp_vpn_xauth_ml_1 group sdm-vpn-server-group-1 loc
al
aaa authentication login ciscocp_vpn_xauth_ml_2 local
aaa authorization exec default local
aaa authorization network ciscocp_vpn_group_ml_1 group sdm-vpn-server-group-1 lo
cal
aaa authorization network ciscocp_vpn_group_ml_2 local
!
aaa session-id common
!
resource policy
!
clock timezone EST -5
clock summer-time edt recurring
ip subnet-zero
no ip dhcp use vrf connected
ip dhcp excluded-address 10.10.10.1
!
ip dhcp pool sdm-pool
import all
network 10.10.10.0 255.255.255.248
default-router 10.10.10.1
lease 0 2
!
!
ip cef
ip domain name TGCSNET.COM
ip name-server 71.242.0.12
ip name-server 71.250.0.12
ip name-server 4.2.2.2
!
!
crypto pki trustpoint TP-self-signed-1164042433
enrollment selfsigned
subject-name cn=IOS-Self-Signed-Certificate-1164042433
revocation-check none
rsakeypair TP-self-signed-1164042433
!
!
crypto pki certificate chain TP-self-signed-1164042433
certificate self-signed 01 nvram:IOS-Self-Sig#3302.cer
username netman privilege 15 secret 5 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
username mynet privilege 15 secret 5 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
!
!
!
crypto isakmp policy 1
encr 3des
authentication pre-share
group 2
!
crypto isakmp policy 2
group 2
!
crypto isakmp client configuration group TGCSVPN
key xxxxxxxxxxxxxx
dns 192.168.69.10 192.168.69.15
wins 192.168.69.10 192.168.69.15
domain our
pool SDM_POOL_1
netmask 255.255.255.0
crypto isakmp profile ciscocp-ike-profile-1
match identity group TGCSVPN
client authentication list ciscocp_vpn_xauth_ml_2
isakmp authorization list ciscocp_vpn_group_ml_2
client configuration address respond
virtual-template 2
!
!
crypto ipsec transform-set ESP-3DES-SHA esp-3des esp-sha-hmac
crypto ipsec transform-set ESP-3DES-SHA1 esp-3des esp-sha-hmac
!
crypto ipsec profile CiscoCP_Profile1
set security-association idle-time 86400
set transform-set ESP-3DES-SHA1
set isakmp-profile ciscocp-ike-profile-1
!
!
bridge irb
!
!
interface Loopback1
ip address 10.69.241.0 255.0.0.0
!
interface FastEthernet0
!
interface FastEthernet1
!
interface FastEthernet2
!
interface FastEthernet3
!
interface FastEthernet4
description $ETH-WAN$
ip address 72.88.223.20 255.255.255.0
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
!
interface Virtual-Template2 type tunnel
ip unnumbered Loopback1
tunnel mode ipsec ipv4
tunnel protection ipsec profile CiscoCP_Profile1
!
interface Dot11Radio0
no ip address
!
encryption vlan 1 mode ciphers tkip
!
ssid 010659120255
!
ssid TGCSNET
vlan 1
authentication open
authentication key-management wpa
guest-mode
wpa-psk ascii 0 010659120255000000
!
speed basic-1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0
channel 2437
station-role root
!
interface Dot11Radio0.1
encapsulation dot1Q 1 native
no snmp trap link-status
no cdp enable
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Vlan1
description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$
no ip address
ip virtual-reassembly
ip tcp adjust-mss 1452
bridge-group 1
bridge-group 1 spanning-disabled
!
interface BVI1
ip address 192.168.69.1 255.255.255.0
ip nat inside
ip virtual-reassembly
!
ip local pool SDM_POOL_1 192.168.70.75 192.168.70.99
ip classless
ip route 0.0.0.0 0.0.0.0 72.88.223.1
!
ip http server
ip http access-class 23
ip http authentication local
ip http secure-server
ip http timeout-policy idle 600 life 86400 requests 10000
ip nat inside source list 110 interface FastEthernet4 overload
ip nat inside source static tcp 192.168.69.26 8080 interface FastEthernet4 8080
ip nat inside source static tcp 192.168.69.26 25 interface FastEthernet4 25
ip nat inside source static tcp 192.168.69.15 80 interface FastEthernet4 80
ip nat inside source static tcp 192.168.69.15 21 interface FastEthernet4 21
ip nat inside source static tcp 192.168.69.15 5900 interface FastEthernet4 5900
ip nat inside source static tcp 192.168.69.26 443 interface FastEthernet4 443
!
ip access-list extended denyDHCP
deny udp any any eq bootpc
deny udp any any eq bootps
permit ip any any
!
ip radius source-interface BVI1
access-list 23 permit 192.168.69.0 0.0.0.255
access-list 110 permit ip 192.168.69.0 0.0.0.255 any
no cdp run
radius-server host 192.168.69.15 auth-port 1645 acct-port 1646
!
control-plane
!
bridge 1 route ip
banner login ^C
-----------------------------------------------------------------------
Cisco Router and Security Device Manager (SDM) is installed on this device.
This feature requires the one-time use of the username "cisco"
with the password "cisco". The default username and password have a privilege le
vel of 15.
Please change these publicly known initial credentials using SDM or the IOS CLI.
Here are the Cisco IOS commands.
username privilege 15 secret 0
no username cisco
Replace and with the username and password you want to use
.
For more information about SDM please follow the instructions in the QUICK START
GUIDE for your router or go to http://www.cisco.com/go/sdm
-----------------------------------------------------------------------
^C
!
line con 0
no modem enable
line aux 0
line vty 0 4
access-class 23 in
transport input telnet ssh
!
scheduler max-task-time 5000
ntp clock-period 17175152
ntp server 141.165.5.137
end
MyRouter#
Thomas R Grassi Jr
