I have users happily connecting to my Cisco ASA via the Cisco VPN client. Now I need to get a contractor to VPN in and I want to create a separate profile for them and only allow then to a certain sunbnet, is this possible?
I would setup a new tunnel-group that assigns this user an IP address from a different DHCP range than the rest of your VPN users, and this is also where you will define the authentication parameters. Then just use an ACL to restrict access to whatever he needs. You could actually use the same group-policy for both groups.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...