Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VPN Client - No access to resources

Hi,

I've just set up a new ASA 5010 running 8.2(1) and I'm trying to configure access via cisco vpn client. I have run the IPSec VPN Wizard in ASDM 6.2 and set up the connection. I've set up the client and it connects without a problem, but I can get no access to any resources. Any ideas?

Regards

Egg

2 REPLIES
Community Member

Re: VPN Client - No access to resources

Hi,

Be sure your ACL for VPN traffic is correctly matching the local subnet you want to reach. More, You ahve to open the flow in the ACL binded to the interface where you crypto map is applied.

HTH

Olivier

Community Member

Re: VPN Client - No access to resources

Hi,

Thanks for the reply.

The ASDM didn't seem to add an acl for remote access in so I added one and applided it to my ouside interface, but still no joy. I've attached my cleaned config if you could have a look.

Thanks

Regards

Egg

197
Views
0
Helpful
2
Replies
CreatePlease to create content