Re: VPN-client set connect to the remote PIX, but has not access
I think the split tunnel access list is written wrong here :)
a rule of thumb, the split tunnel access list should always contain the traffic to be secured, so we need the clients ip pool to be as the source of the access list and the required secure networks to be the destination, so our split tunnel access list should look like this:
access-list rem-vlg_splitTunnelAcl permit ip 10.10.100.0 255.255.255.0 192.168.10.192 255.255.255.224
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...