I use a pcf to connect to a remote asa. It works from several locations, however there is one that it does not. I included a route print from my workstation while connected from both a working and non working location. The top route print is the non working. The difference i noticed between the two of them is the second line. On the non working the gateway is the address the ASA assigns to the client 10.10.101.106 on the bottom route print the gateway is correct 10.10.101.1. I believe this is where the problem is. If anyone has input on this it is much appreciated.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...