Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VPN configuration error

I have a Cisco Systems, PIX 515e firewall and an SMC router barricade I am trying to built an ipsec vpn tunnel, between the two devices, I configure the two devices with the same configuration but when I try connect to the remote site, I have the following error

3|May 15 2008|18:07:16|713902|||IP = 213.138.231.11, Invalid packet detected!

3|May 15 2008|18:06:56|713902|||IP = 213.138.231.11, Removing peer from peer table failed, no match!

3|May 15 2008|18:06:51|713193|||Received packet with missing payload, Expected payload: 4

3|May 15 2008|18:06:28|713902|||IP = 213.138.231.11, Invalid packet detected!

3|May 15 2008|18:06:08|713902|||IP = 213.138.231.11, Removing peer from peer table failed, no match!

3|May 15 2008|18:06:04|713902|||IP = 213.138.231.11, Invalid packet detected!

3|May 15 2008|18:06:03|713193|||Received packet with missing payload, Expected payload: 4

This Vpn was working between a Linksys router and the smc barricade with the same settings.

Thank you so much in advance and I will be looking forward for the information.

1 REPLY
Community Member

Re: VPN configuration error

Looks like you might have a pre-shared-key mismatch. Make sure your "interesting traffic" config is the same on both ends too.

345
Views
0
Helpful
1
Replies
CreatePlease to create content