Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

Bronze

VPN Design Question

Newbie here so trying to understand some of this vpn features.

I currently have 2 WAN site (SJ and NJ) which have a /30 address ptp Router(with AIM) VPN to each other in case our WAN goes down. The routers are behind a ASA-FW with static NAT.

We will be adding a 3rd WAN site (London) that has similar topology (Router w/VPN-AIM) and a ASA and I was wondering what would be the best design.

I was reading up on DMVPN/mGRE and wonder if I should migrate to DMVPN or do I just setup a full mesh ptp btwn SJ,NJ, and London.

Thanks

130
Views
0
Helpful
0
Replies
CreatePlease to create content