I have a L2L vpn between a Cisco VXR7206 and a Checkpoint firewall. Everything has been running great for almost three years without any issues. Nothing has been changed by either sides for the past three years.
For the past three days, i have been getting a lot messages like this below:
There is insufficient information in this message to properly troubleshoot the situation. The error message should state the source and destination IP addresses and possibly a packet dump. This symptom is observed on a router that functions in an VPN environment, with hardware crypto accelerator.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...