We are testing the upgrade from version 8.2 to 8.4 on an ASA 5505 and ran into a problem. For VPN connections we had pools created. A few of the pools were limited to a single IP address. After the upgrade the ASA rejects the pools that only had one IP address instead of a range. In the command line if you enter a question mark after typing in "ip local pool (pool keyword)" in config mode it says "Specify an IP address or a range of IP addresses:start[-end]" with the word "or" it sounds like it should except a single IP address but it doesn't. The error is "Please enter a valid IP address range."
Does anyone know the soultion to this problem besides increasing the range?
Thank you for the replies. That is how we use to do it. We had a range with the same ip address as the start and end but that gives us the error. So we tried just using the address and that gives us the error too.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...