Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

VPN IPSEC client not accessing local network

This is all new to me so I need some help. I have a 5510 device that I want to use for VPN only. I have followed the quick start guide for initial config and also ran the IPSEC VPN wizard. I have a client that has 4.6 installed. I can make a connection to the ASA with no problem. I can't get traffic to the network though. I can ping the inside interface with the tunnel created but cannot ping the gateway used on the local network. Any ideas?

1 REPLY
Community Member

Re: VPN IPSEC client not accessing local network

Hi

I think its because your sending all your traffic to the ASA. You need to create a split-tunneling and exclude your local lan from getting sent to the ASA

http://cisco.com/en/US/products/ps6120/products_configuration_example09186a0080702992.shtml#s2

I think thats the right guide

GL!

117
Views
0
Helpful
1
Replies
CreatePlease to create content