Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VPN on Cisco 851 W-G-A-K9

I need help setting up VPN on my CISCO 851 W-G-A-K9 version 12.3

I read on the cisco site that it supports VPN  and L2TP and PPTP Tunnels

I did a show VPDN and itt shows no tunnels setup

I use a hyper terminal connection and make all my changes via command line

I run a windows 2003 server environment with active directory that I have some remote users that I would like to logon to the network

I also have a laptop that I would like to take on the road and be able to logon via vpn

what commands would I need to set this up

I can do simple command like

enable

conf t

ip nat inside source static tcp xxx.xxx.xxx.xxx 25 interface FastEthernet4 25

exit

wr mem

enable

any ideas or suggestions

Thanks

Tom

6 REPLIES

VPN on Cisco 851 W-G-A-K9

Goto the below URL - there are plenty of config examples.

HTH>

New Member

VPN on Cisco 851 W-G-A-K9

Andrew

Thanks for replying

Your url did not show up on your reply

could you report it

many thanks

Tom

VPN on Cisco 851 W-G-A-K9

New Member

VPN on Cisco 851 W-G-A-K9

Andrew

No problem thanks  Merry Christmas

I went to that link and founds tons of information but only show 3 articles about my router  851 all about wireless setups.

nothing on vpn

you think if I email you my current config you could take a look at it to see what commands I need to setup vpn?

Thanks

Tom

VPN on Cisco 851 W-G-A-K9

Really??? - On that URL I see it may not be 851 specific, but the process should be the same.....

Configuring an IPsec Router Dynamic LAN-to-LAN Peer and VPN Clients

10/May/2007

&

Configuring IPSec Between a Cisco IOS Router and a Cisco VPN Client 4.x for Windows Using RADIUS

08/Nov/2006

HTH>

New Member

VPN on Cisco 851 W-G-A-K9

Andrew

I downloaded CCP and used the interface program to configure VPN there seems to be a lot of informatin that needs to be configured.

I got vpn setup but when I complted the definition of vpn I ran a test and it failed to start the interface

any ideas?

Thanks

Tom

838
Views
0
Helpful
6
Replies
CreatePlease to create content