cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1964
Views
0
Helpful
2
Replies

VPN on Cisco Router 1841

FRasuli01
Level 1
Level 1

Hello,

I need to configure vpn site-to-site on router cisco 1841, but the problem is that , router does not recognise the crypto comand.

 

R1#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
R1(config)#crypto?
% Unrecognized command
R1(config)#crypto ?
% Unrecognized command
R1(config)#c?
call             call-history-mib  carrier-id  cdp
chat-script      class-map         clock       cns
config-register  configuration     connect     control-plane

R1(config)#crypto isakmp policy 1

                    ^
% Invalid input detected at '^' marker.

 

 

R1#sh ver
Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(1c), RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Tue 25-Oct-05 17:10 by evmiller

ROM: System Bootstrap, Version 12.3(8r)T9, RELEASE SOFTWARE (fc1)

cs-Khatlon-opio-01 uptime is 2 days, 23 hours, 1 minute
System returned to ROM by reload at 16:07:44 TJK Fri Nov 7 2014
System image file is "flash:c1841-ipbase-mz.124-1c.bin"

Cisco 1841 (revision 6.0) with 114688K/16384K bytes of memory.
Processor board ID FCZ102110NQ
2 FastEthernet interfaces
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
31360K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x3922

 

Please help , How to configuer vpn?

 

1 Accepted Solution

Accepted Solutions

Hello,

 

According to this output is more than clear that you don't have a k9 license applied to this router, this license will allow security features on your IOS, on this case you will need to get a k9 license with an activation key and then you will be able to have the crypto commands available on your device. Once you have this we can work on the site to site configuration.

 

Don't forget to rate!

 

David Castro,

 

Regards,

View solution in original post

2 Replies 2

Hello,

 

According to this output is more than clear that you don't have a k9 license applied to this router, this license will allow security features on your IOS, on this case you will need to get a k9 license with an activation key and then you will be able to have the crypto commands available on your device. Once you have this we can work on the site to site configuration.

 

Don't forget to rate!

 

David Castro,

 

Regards,

FRasuli01
Level 1
Level 1

Thank You! I have to change the IOS.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: