Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VPN primary and backup peer

We have one router (Cisco 3925E) to setup L2L VPN.

From our end, there is only one IP, But there is two IPs (Primary 10.1.1.1 and Backup 20.2.2.2) at client end. The client want to VPN failover. 

I set up 2 Peers for this. 

Crypto map WAN 10 ipec-isakmp

set peer 10.1.1.1

set peer 20.2.2.2

 

Client complains that it has happened all time for disconnection. After I take second IP (20.2.2.2)out. It runs OK.

There is a feature called IPsec Prefered Peer. But I check this feature is not available on Cisco 3925E and 3945E (I hope my check wrong).

Does any one know how to configure VPN failover for this scenario?

 

 

33
Views
0
Helpful
0
Replies