Hello, I recently installed the Cisco RV110W, I configured the VPN connection parameters and are able to connect via QuickVPN. The only problem is that the address is obtained IPV6.
The router I configured WAN IPV4 and LAN IPV4 then I do not understand where he got the parameters of IPV6 but above all how can I change this parameter, because even if I log in I can not see anything at all on the network, as everything else is configured with IPV4.
Can someone give me some help because I can not find anything in the manuals or online.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...