So I have to set up a VPN for the EMS' Trucks. Their IT guy said something's wrong with their IP scheme and I would have to use the MACs when I set the tunnel up. I have never used MAC addresses to set up a VPN before. What command will be different from using IPs? Will I have to do MAC binding?
I have the access point set up. I just need to set the ASA up. Under the group policy the command when using IP address is vpn-framed-ip-address. But Im using the MAC address since the IPs they have are dynamic. I dont know what command to put in place to use the MAC address. Anybody know?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...