Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

vpn tunnel failed after changing ISP - no outgoing traffic

Hi forum,

Sorry, I am trying hard on this problem. initially my ASA firewall can ping the destination ASA firewall public IP. But after changing the ISP, by adding another router in front, I can't ping the remote ASA IP address, I am not sure this is the cause of my VPN tunnel to fail. but Internet access has no problem.

I really appreciate if anyone can help.

Thank you,

paul

---------------------------------.

Following are some errors captured:

Message #92 : Feb 06 00:48:54 [IKEv1]Message #93 : : IP = 2.2.2.2, Removing peer from peer table failed, no match!

Message #94 : Feb 06 00:48:54 [IKEv1]Message #95 : : IP = 2.2.2.2, Error: Unable to remove PeerTblEntry

Message #96 : Feb 06 11:39:40 [IKEv1]Message #97 : : Group = 2.2.2.2, IP = 2.2.2.2, Removing peer from peer table failed, no match!

Message #98 : Feb 06 11:39:40 [IKEv1]Message #99 : : Group = 2.2.2.2, IP = 2.2.2.2, Error: Unable to remove PeerTblEntry

Message #100 :

IKE_TMR DPD_TIMER (0x01383360) popped @ time = 1229314

<--- More --->

Message #101 :

IKE_TMR DPD_TIMER (0x01383360) popped @ time = 1229315

Message #102 :

Message #125 :

IKE_TMR REAPER_TIMER (0x01388260) popped @ time = 1229336

Message #126 :

Message #135 :

IKE_TMR DPD_TIMER (0x01383360) popped @ time = 1229345

Message #136 :

IKE_TMR BACKUP_L2L (0x013833d0) popped @ time = 1229346

Message #137 :

IKE_TMR REAPER_TIMER (0x01388260) popped @ time = 1229346

Message #138 :

IKE_TMR DPD_TIMER (0x01383360) popped @ time = 1229346

Message #139 : Feb 07 19:21:26 [IKEv1]Message #140 : : IP = 2.2.2.2, Removing peer from peer table failed, no match!

Message #141 : Feb 07 19:21:26 [IKEv1]Message #142 : : IP = 2.2.2.2, Error: Unable to remove PeerTblEntry

Message #143 : Feb 07 19:21:27 [IKEv1]Message #144 : : IP = 2.2.2.2, Header invalid, missing SA payload! (next payload = 4)

Message #145 : Feb 07 19:21:34 [IKEv1]Message #146 : : IP = 2.2.2.2, Header invalid, missing SA payload! (next payload = 4)

Message #147 : Feb 07 19:21:42 [IKEv1]Message #148 : : IP = 2.2.2.2, Header invalid, missing SA payload! (next payload = 4)

Message #149 : Feb 07 19:21:50 [IKEv1]Message #150 : : IP = 2.2.2.2, Header invalid, missing SA payload! (next payload = 4)

Message #151 : Feb 09 05:28:00 [IKEv1]Message #152 : : IP = 2.2.2.2, Removing peer from peer table failed, no match!

Message #153 : Feb 09 05:28:00 [IKEv1]Message #154 : : IP = 2.2.2.2, Error: Unable to remove PeerTblEntry

Message #155 : Feb 09 16:13:36 [IKEv1]Message #156 : : IP = 2.2.2.2, Removing peer from peer table failed, no match!

Message #157 : Feb 09 16:13:36 [IKEv1]Message #158 : : IP = 2.2.2.2, Error: Unable to remove PeerTblEntry

pixfirewall# ping 2.2.2.2

Sending 5, 100-byte ICMP Echos to 2.2.2.2, timeout is 2 seconds:

ICMP echo reply from 2.2.2.2 to 1.1.1.1 ID=4388 seq=58029 len=72

Denied ICMP type = 0, code = 0 from 2.2.2.2on interface 1

?ICMP echo reply from 2.2.2.2 to 1.1.1.1 ID=4388 seq=58029 len=72

Denied ICMP type = 0, code = 0 from 2.2.2.2on interface 1

?ICMP echo reply from 2.2.2.2 to 1.1.1.1 ID=4388 seq=58029 len=72

2 REPLIES
Cisco Employee

Re: vpn tunnel failed after changing ISP - no outgoing traffic

Hi,

Did you get the peer IP changed on the remote device?

If not, then please get that done.

HTH,

Please rate if it helps.

Regards,

Kamal

Community Member

Re: vpn tunnel failed after changing ISP - no outgoing traffic

Hi Kamal,

Yes, the peer IP for the remote device was changed.

#pkts encaps: 0, #pkts encrypt: 0, #pkts digest: 0

#pkts decaps: 52069, #pkts decrypt: 52069, #pkts verify: 52069

I cannot see pkts encrypt, etc.

Removing peer from peer table failed, no match! ====> what is the meaning of this message?

Thank you very much,

paul

558
Views
0
Helpful
2
Replies
CreatePlease to create content