My location is using a PIX 515 firewall to do both a site-to-site connection and allow remote users to VPN in to the local network. I have modified the IP addresses slightly, but in the attached configuration file, 10.20.20.0/24 is my local network, 10.30.30.0/24 is the network on the other side of the site-to-site VPN tunnel, 192.168.51.0/240 is the network for the VPN remote access users and 10.40.40.0/24 is the "network" between the PIX firewall and the local network router. Configuration is as follows: <local network> - <router> - <pix> - <Internet / VPN Site-to-Site>.
My problem is that I can successfully access computers on the 10.30.30.0 network from the 10.20.20.0 network, but I can't access 10.30.30.0 computers from the 192.168.51.0 network (although the 192.168.51.0 network can access computers on the 10.20.20.0 network).
In short, I'm trying to allow access to computers over the site-to-site VPN tunnel via users on the other side of the Remote-Access tunnel.
I have attached the running-configuration from the PIX firewall to this conversation.
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in HA
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationCo...
I am currently unable to specify "crypto keyring" command when configuring VPN connection on my cisco 2901 router.
The following licenses have been activated on my router :