Is there anyway to find out the vpn username (and maybe password) from within the OnConnect script?
The point being to make a single-signon type solution for maping network drives on a laptop that is not in the domain. The users have already entered their username and password into the anyconnect client and it would be a bit annoying to enter it again. I could see potential security problems with this, but maybe it could be done securely.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...