Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VPN3000 to ASA migration issue - Error processing payload: Payload ID: 14

Hi,

I have migrated from a VPN3000 to an ASA running 8.0(4). While it works fine for 1200+ users, around 30 users are unable to connect. Once authenticated the VPN drops.

The syslogs are recording the following;

%ASA-3-713048...Error processing payload: Payload ID: 14

If I enable debugging, I see the following against some of the affected users;

%ASA-5-713130...Received unsupported transaction mode attribute: 5

NB. We are using one time password, therefore RADIUS Authentication doesnt require passwords to be reset, I note a similar post provides a solution for RADIUS authentication with passwords -the "password-management" command - but that doesnt appear to apply in our case.

Anybody know what these mean? or what could be causing it?

Thanks, Carl

1 REPLY
Bronze

Re: VPN3000 to ASA migration issue - Error processing payload: P

Explanation This message indicates that a packet has been received with a payload we could not process.

Recommended Action If this problem persists, there might be a misconfiguration on the peer.

Error Message %ASA-5-713130: Received unsupported transaction mode attribute: attribute id

Explanation This message indicates that the device received a request for a valid transaction mode attribute (XAUTH or Mode Cfg) that is currently not supported. This is generally a benign condition.

Recommended Action None required.

4516
Views
0
Helpful
1
Replies