04-19-2006 11:16 PM
Dear All,
I'm trying to configure a PIX 515E with 7.1.2 software to enable WebVPN.
I'm following istructions from this document:
When I enter the command to enable WebVPN the PIX responds "invalid input":
---------
Cisco PIX Security Appliance Software Version 7.1(2)
Device Manager Version 5.1(2)
Compiled on Tue 14-Mar-06 17:00 by dalecki
System image file is "flash:/image.bin"
Config file at boot was "startup-config"
01-gw up 11 days 6 hours
Hardware: PIX-515E, 128 MB RAM, CPU Pentium II 433 MHz
Flash E28F128J3 @ 0xfff00000, 16MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB
Encryption hardware device : VAC+ (Crypto5823 revision 0x1)
0: Ext: Ethernet0 : address is 0011.2094.1dfd, irq 10
1: Ext: Ethernet1 : address is 0011.2094.1dff, irq 11
2: Ext: Ethernet2 : address is 000d.88ee.b394, irq 11
3: Ext: Ethernet3 : address is 000d.88ee.b395, irq 10
4: Ext: Ethernet4 : address is 000d.88ee.b396, irq 9
5: Ext: Ethernet5 : address is 000d.88ee.b397, irq 5
Licensed features for this platform:
Maximum Physical Interfaces : 6
Maximum VLANs : 25
Inside Hosts : Unlimited
Failover : Active/Active
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Cut-through Proxy : Enabled
Guards : Enabled
URL Filtering : Enabled
Security Contexts : 2
GTP/GPRS : Disabled
VPN Peers : Unlimited
This platform has an Unrestricted (UR) license.
Serial Number: xxxxxx
Running Activation Key: xxxxxxxxxxxxxxxxxx
Configuration last modified by enable_15 at 19:17:27.161 CEDT Wed Apr
19 2006
01-gw(config)# webvpn
^
ERROR: % Invalid input detected at '^' marker.
01-gw(config)#
Thanks in advance,
Antonio
04-20-2006 11:55 AM
I seem to recall that the configuration guide used to state that this was on the ASA products only (not on the PIX).
I would do a little research to investigate if it is possible, but I believe this support is limited to the ASA-line.
04-20-2006 12:54 PM
hi i am sure that cisco pix shows all the commands for webvpn but it doesn't support webvpn. it's only supported on asa. they have kept the configuration document same for both of them .
sebastan
04-20-2006 04:10 PM
It's Supported in ASA 7.0 only as a demo with 7.1 you have to get a feature license and I think install additional software.
Here is the feature licensing information for the ASA and PIX's if you'll notice the VPN Peers the ASA has webvpn available and the Pix does not.
http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a00804512ab.html
Patrick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide