Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

What exactly causes "Removing peer from peer table failed, no match" on ASA

Hello,

ASA1 <--> ASA2 VPN tunnel stable, works fine. One end has Internet issues and once resolved, the L2L tunnel took some time to establish. ASAs logging messages, "Removing peer from peer table failed, no match!". What exactly cause this issue ?

Thank you

MS

7 REPLIES

Re: What exactly causes "Removing peer from peer table failed, n

Basically it means 1 of 2 things:-

1) You have lan2lan peers config - and a remote IP address is trying to connec, that you have not configured

2) A remote VPN client session is trying to connect - and you have not configured the remote dynamic VPN

HTH>

New Member

Re: What exactly causes "Removing peer from peer table failed, n

Hi Andrew,

Thanks for the reply.. but the l2L VPN has been in place from long time. The issue was observerved only when the interent has issues for some time recovered. IPs are inplace.

Nothing to do with Remote client session.

Thanks

MS

New Member

Re: What exactly causes "Removing peer from peer table failed, n

same problem here b/n ASA and 1841s in hub/spokes config, caused by power or Internet outages.

I reestablish the connection via "clear crypto ipsec sa" command on the hub (ASA 5510), but I did not find a cause yet

New Member

Re: What exactly causes "Removing peer from peer table failed, n

Have you found a cause for this? I've seen the same too in a very similar setup.

New Member

Re: What exactly causes "Removing peer from peer table failed, n

This is pretty much a generic log that occurs after an IPSEC negotiation fails for just about any reason. Turn on debugging and look at the messages preceding this to find out why that particular negotiation failed. This message is generated by the cleanup routine that follows a failed negotiation. It can't find an entry in the table because the negotiation failed before it put an entry in the table.

New Member

Re: What exactly causes "Removing peer from peer table failed, n

I second this!

Bronze

Re: What exactly causes "Removing peer from peer table failed, n

Run 'debug crypto isak 254' to find out what triggered this event.

Or configure a logging list to just capture vpn debugging messages.

16331
Views
0
Helpful
7
Replies