Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Where do I enter endpoint name in WRVS4400N for a dynamic IP?

I have a Snapgear 560U VPN Gateway at the main office with VPN connections to several branch offices also using Snapgear 560U. Those are no longer manufactured though, so I bought a Cisco WRVS4400N for our new office. The main office has a fixed IP but the branch office ha a dynamic one. On the Snapgear's it is very clear where I need to enter the Mandatory endpoint name on the dynamic side of the tunnel, but I can't find anything on this on the Cisco WRVS4400N. So where do I enter this information so that I can make a VPN connection between the Snapgear & Cisco boxes?

Thanks in advance, Jason.

1 REPLY
Cisco Employee

Where do I enter endpoint name in WRVS4400N for a dynamic IP?

Hi Jason,


since this question is about a product in the Cisco Small Business / Linksys range, I suggest you move it to the community, where you will have a better chance of getting expert advice.


best regards,

Herbert
Cisco Moderator

442
Views
0
Helpful
1
Replies
CreatePlease to create content