Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WRVS4400N VPN IPsec gateway to gateway setup

Hi,

Just bought 3 WRVS4400N, I wanted to setup gateway to gateway VPN.  I followed the instructions on the WRVS4400N admin guide and VPN does not connect.  I also downloaded the VPN setup wizard and that also did get the gateway connected.  Everything seems to be correct.  Do I have to enable anything else?  Firewall setting?

Below is my config.

IPSec VPN Tunnel: Enabled

Tunnel Name: TUN01

Local Security gateway: IP only

WAN1 IP: 192.168.100.1

SUBNET: 255.255.255.0

Local Security type: subnet

LOCAL IP: 10.10.10.1

SUBNET: 255.255.255.0

Remote Security gateway: IP Only

WAN2 IP: 192.168.200.1

SUBNET: 255.255.255.0

Remote Security Group Type:

LOCAL IP: 10.10.20.1

SUBNET: 255.255.255.0

IPSec Setup

Keying Mode: IKE with PreShared Key

Phase 1:

Encryption:   3DES

Authentication:  MD5        

Group:     768-bit

Key Lifetime:     86400 sec

Phase 2:

Encryption:     3DES

Authentication:     SHA1

Perfect Forward Secrecy:     Enabled

Preshared Key:     ABCD1234

Group:     768-bit

Key Lifetime:     28800  sec

1 REPLY
Cisco Employee

WRVS4400N VPN IPsec gateway to gateway setup

Hi Jane,


since this question is about a product in the Cisco Small Business / Linksys range, I suggest you move it to the community, where you will have a better chance of getting expert advice.


best regards,

Herbert
Cisco Moderator

1068
Views
0
Helpful
1
Replies
CreatePlease login to create content