Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Zone Based FW: Adding secondary address to an interface

If you set up a secondary IP address on an interface - say int fa0/0 zone "inside" - does that immediately take effect for the traffic on that subnet? I will be working on a network where they installed too small a subnet on the inside and I'd like to ease the migration by putting on a secondary IP and let them renumber all their stuff etc. Then as final brief step I'll nuke the primary address and make the secondary primary.

Would this work? Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Zone Based FW: Adding secondary address to an interface

once u put the secondary it comes into effict

but i think for nating u need to make reload

or rstart the sessions

good luck

1 REPLY

Re: Zone Based FW: Adding secondary address to an interface

once u put the secondary it comes into effict

but i think for nating u need to make reload

or rstart the sessions

good luck

105
Views
0
Helpful
1
Replies