Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

1-port OC-3 ATM Enhanced perf Single mode Long NM 3

Dear All,

we have a cisco 3745 equipped with "1-port OC-3 ATM Enhanced perf Single mode Long NM 3" Module , do the specification of this midule match the G. 957 Standard ?

second question : is it possible to connect this module to single mode mode fiber of 5 km length maximun coming from Service Provider without using any attenuator ?

Thanks and Regards

Yaacoub

1 REPLY

Re: 1-port OC-3 ATM Enhanced perf Single mode Long NM 3

Hello,

the best way to go is to request from the SP the information about the dampening of the specific fiber to be used. Usually this is measured during initial installation of the fiber. Once you have the value and also get the info about the other ends transmitter output power you can calculate the power your receiver has to expect. Compare it with the receiver specs and you will know whether an attenuator is needed or not.

Hope this helps! Please rate all posts.

Regards, Martin

96
Views
4
Helpful
1
Replies
CreatePlease to create content