Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

10K router

Hi

I am trying to configure MFR on my 10K router, It cannot take the interface-dlci command. Once the dlci is configured I am getting an error message, what could this be. is it a bug that needs to be fixed by cisco?

below are my configs:

interface MFR0

no ip address

no keepalive

frame-relay intf-type dce

!

interface MFR0.100 point-to-point

ip address xxx.xxx.x.x 255.255.255.252

!

Router(config-subif)#frame-relay interface-dlci 120

Router(config-subif)#

1d20h: %GENERAL-3-EREVENT: dlci_create: No c10k_tt_hwsb

-Traceback= 6125CD0C 60EC4E2C 60EC572C 60ECF648 60EC3F94 6053608C 601C5AA8 605511FC 606585E0 606585CC

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: 10K router

Contact the TAC about this, it's likely a bug.

1 REPLY
Hall of Fame Super Gold

Re: 10K router

Contact the TAC about this, it's likely a bug.

209
Views
0
Helpful
1
Replies