I have a 1760 router that have two wic cards on slot 0 and 1. And 2 vic 4fxs/did cards on slot 2 and 3.
Problem is that the two vic4fxs/did cards, don't show up on hardware list, there is a green light on the slot 2 and 3 that is OK, the 4 ports on each card are amber, but the router doesn't reconize the card.
Is ther any comand that I have to do to enable the card on the slot, for fxs?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...