I have a new 1811 router. Am attempting to install PPPoE on the two WAN links to talk to two Speedstream ADSL modems. Each ADSL line has a fixed IP in the same subnet. I can get one of the links to come up but I cannot get the download speeds up. I have attempted to set the MTU but not having any luck here. Is there a standard configuration available to set up two ADSL modems in a failover/loadbalance setup? How do I optimize each connection then set it up to load balance.
If I plug the ADSL modem into my existing Netgear router I get download speeds of 800k with the same modem plugged into the 1811 the download speed is about 110k. The upload speeds are similar.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...