During connect to provider, he authenticates me successfully moreover I got public ip but can not ping anything.
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 22.214.171.124, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) gate#
I'm able ping outside ips for example public DNS server (126.96.36.199) only using extended ping like:
gate#p Protocol [ip]: Target IP address: 188.8.131.52 Repeat count : Datagram size : Timeout in seconds : Extended commands [n]: y Source address or interface: Ethernet0 Type of service : Set DF bit in IP header? [no]: Validate reply data? [no]: Data pattern [0xABCD]: Loose, Strict, Record, Timestamp, Verbose[none]: Sweep range of sizes [n]: Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 184.108.40.206, timeout is 2 seconds: Packet sent with a source address of 192.168.172.1 !!!!! Success rate is 5 percent (5/5) gate#
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...