FE0/0 needs to accept NAT translation requests coming from the IP 22.214.171.124/28
FE0/1 needs to route (default router) for machines on other IP's in the /28 subnet.
Default route for FE0/1 needs to go out ADSL1
Default route for FE0/0 needs to NAT, load balance and failover both ATM0/0/0 and ATM0/1/0
I need a virtual interface of some sort that will allow me to assign the IP 126.96.36.199/28 to it, and set it as IP NAT OUTSIDE.
I visualise it as follows:
ATM0/0/0 coupled to Dialer0 get assigned the IP 188.8.131.52/32 on the actual Dialer0 interface. The subnet 184.108.40.206/28 is routed via that /32 IP on the Dialer0 interface. 220.127.116.11/28 is the first IP and the gateway IP for the subnet and is assigned to the FE0/1 interface. The FE0/1 interface needs to static route (no NAT) to the Dialer0 interface.
I now need a "virtual" interface with the IP 18.104.22.168/28 which will static route to the FE0/1 interface. This interface needs to be set as IP NAT OUTSIDE so that port forward requests coming in via Dialer0->FE0/1->Virtual are port mapped to FE0/0
ATM0/1/0 coupled to Dialer1 get assigned a static /32 IP and will accept port forward requests directed to the FE0/0 interface only.
FE0/0 needs to NAT to both Dialer1 and the virtual interface with 178/28 for load balancing and failover.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...