Hi, I am setting up a Cisco 1841 Router to 2 ISP connections. The first connection is a T1 and the second connection is a Cable Modem. I have setup PAT in conjunction with route-maps that will send all www traffic out the cable modem and all other traffic out the T1. The Cable Modem connection is dynamic. I can successfully FTP to different sites using the T1 connection but when I try and browse to any website it eventually times out and won't load the page. Is there anything I am missing for the DHCP side or any side for that matter that would cause problems with the Cable Modem connection? Here is the config.
Please remove them and configure like "permit ip tcp 192.168.254.0 0.0.0.255 ".
Alos, you neet PBR in addition to route map if you want to send all your WWW address to a particular interface. for that, I think you can use the "permit tcp any any type". In these, you need "set interface ..." depending on where you want to send traffic.
I tried the changes to the ACL for the Route-Maps used by NAT. I also got rid of the match commands to the interfaces and entered in set commands to the proper interfaces. After doing so it has not changed anything. Still having problems witht he Cable side and the T1 side is very slow finding ftp sites. You said I need PBR which I am assuming is policy based routing. I thought routemaps were policy based routing which is included in the NAT commands. Do you have any other ideas that might help resolve the issue? Here is the new config:
ip dhcp excluded-address 192.168.254.1 192.168.254.49
ip dhcp excluded-address 192.168.254.100 192.168.254.254
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...