Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1841 interface modules

I am trying to determine which interface module I need to provide a ethernet interface to the 1841. I have a fractional T1 in the one interface, but want to bring in a second network segment from one of my switches. Can someone point me to the correct WIC?

Thanks

4 REPLIES
Hall of Fame Super Bronze

Re: 1841 interface modules

Here is the list of modules for the 1800:

http://www.cisco.com/en/US/products/ps5853/products_relevant_interfaces_and_modules.html

HWIC-4ESW seems to fit the bill.

HTH,

__

Edison.

Hall of Fame Super Silver

Re: 1841 interface modules

Hello,

The Cisco 1841 router has two interface card slots. Each slot can accommodate a Cisco WIC, VWIC (data only mode), or a single-wide high-speed WIC (HWIC).

Note Cisco double-wide HWICs are not supported in the Cisco 1841 router.

But I cannot find the list of the allowed modules I would guess NM-1FE2W.

Hope to help

Giuseppe

Hall of Fame Super Bronze

Re: 1841 interface modules

Note Cisco double-wide HWICs are not supported in the Cisco 1841 router.

Are you sure?

http://www.cisco.com/en/US/prod/collateral/routers/ps5853/product_data_sheet0900aecd8016bf0b.html

Cisco 1841

4-Port Cisco EtherSwitch HWIC

Yes, 2 HWICs per router

New Member

Re: 1841 interface modules

ediortiz,

yes Cisco 1841 doesn't support the double-wide form factor (i.e. HWIC-D-9ESW), it supports 2 Single-wide HWICs!

144
Views
0
Helpful
4
Replies